Pay attention to the oil cooling lines!

[Zak]

[Zak]

I solved this problem myself.  put on a reinforced hose and tightened with clamps.  the mileage of the motorcycle is only 1,500 km.

[motorman]

Very good idea.  Something to be looked into on a reg basis!

[Goldstar]

I had this issue when the bike was virtually new, pipes replaced under warranty....

https://www.multistrada950.com/index.php/topic,329.msg2019.html#msg2019

[neilb]

Makes a note to take a look at them tomorrow, but no leaks after 40000 miles.

[Julian]

The dealer fittet for me the same fix as Zak posted. I think he knew something... I haven't inspected the area, but tomorrow I will take a look.

[Wassers]

I'll check mine later today, but I've only done 350 miles prior to lockdown, so I better not have a problem brewing 

[Desmofonso]

Same issue in mine a year ago. I solved this two ways:
1.- Grinding the radiator plate that wear the hoses. (I used a Dremel to did it)
2.- Redirecting the hoses from the conection to the motor, make possible keep the distance in the radiator.
Regards.

[neilb]

Originally Posted by neilb

Makes a note to take a look at them tomorrow, but no leaks after 40000 miles.

Just checked mine and couldn’t find any wear on the tubes.

[leodesmo]

When I installed the GiVi engine guard myself on the MTS 950S 2019 I added a similar solution that was given with the kit, including the instructions on how to install it. I noticed that the pipes were reinforced  outside with a kind of spring and the rubber; if I remember correctly I added  a second rubber layer.