Author Topic: Fitting aftermarket levers  (Read 319 times)

0 Members and 1 Guest are viewing this topic.

  • Offline Kwack   gb

    • MTS 950 Junior  ‐    4
    • *

    Offline Kwack

    • MTS 950 Junior
    • *
    • Posts: 4
    • Country: gb
    • Town / City: Watford
    Fitting aftermarket levers
    on: December 15, 2021, 01:48:47 pm
    December 15, 2021, 01:48:47 pm
    Hi

    Just got a set of aftermarket levers. On the brake aide I undid the Allen bolt and nut and expected the lever to come out. Usually on other bikes I have done

    What am I missing?

    Cheers

  • Offline Kwack   gb

    • MTS 950 Junior  ‐    4
    • *
      #1

    Offline Kwack

    • MTS 950 Junior
    • *
    • Posts: 4
    • Country: gb
    • Town / City: Watford
    Re: Fitting aftermarket levers
    Reply #1 on: December 15, 2021, 10:36:26 pm
    December 15, 2021, 10:36:26 pm
    Done

  • Offline Kwack   gb

    • MTS 950 Junior  ‐    4
    • *
      #2

    Offline Kwack

    • MTS 950 Junior
    • *
    • Posts: 4
    • Country: gb
    • Town / City: Watford
    Re: Fitting aftermarket levers
    Reply #2 on: December 16, 2021, 12:15:08 pm
    December 16, 2021, 12:15:08 pm
    Although I seem to have lost the small ball bearing type thing that sits between the end of the lever and the microswitch so the brakes are permanent on

    Any ideas what size this is so I could try and use something else or even whether it comes as part of a replacement microswitch

    What a pain.

    Thanks

  • Offline buzzardbilly   gb

      #3

    Offline buzzardbilly

    • MTS 950 Pro
    • ***
    • Posts: 282
    • Country: gb
    • Town / City: Gloucester
    Re: Fitting aftermarket levers
    Reply #3 on: December 16, 2021, 07:24:41 pm
    December 16, 2021, 07:24:41 pm